Download HP 16510A

Transcript
SAFETY CONSIDERATIONS
GENERAL • This Is a Safety Class I Instrument (provided
o Do not Install substitute parts or perform any unauthorized
with terminal for protective earthing).
modification to the Instrument.
OPERATION· BEFORE APPLYING POWER verify that the
o Adjustments described In the manual are performed with
power transformer primary Is matched to the available line
voltage, the correct fuse Is Installed, and Safety Precautions
are taken (see the following warnings)., In addition, note the
power supplied ~o the Instrument while protective covers
are removed. Energy available at many pOints may, If
contacted, result In personal injury.
instrument's external markings which are described under
"Safety Symbols."
o Any adjustment, maintenance, and repair of the opened
Instrument under voltage should be avoided as much as
I
WARNING
I
possible, and when inevitable, should be carried out only by
a skilled person who Is aware of the hazard Involved.
o Servicing Instructions are for use by service-trained
personnel. To avoid dangerous electric shock, do not
o Capacitors Inside the Instrument may stili be charged even
If the Instrument has been disconnected from Its source of
perform any servicing unless qualified to do so.
o BEFORE
SWITCHING
ON
THE
supply.
INSTRUMENT,
the
protective earth terminal of the Instrument must be
connected to the protective conductor of the (mains)
powercord.
SAFETY SYMBOLS
The mains plug shall only be Inserted In a
&
socket outlet provided with a protective earth contact. The
protective action must not be negated by the use of an
extension
cord
(power
cable)
without
a
protective
conductor (grounding). Grounding one conductor of a two-
Instruction manual symbol. The product will be
marked with this symbol when It Is necessary for
the user to refer to the Instruction manual In order
to protect against damage to the product.
conductor outlet Is not sufficient protection.
o If
this
Instrument
Is
to
be
energized
via
an
Indicates hazardous voltages.
auto-transformer (for voltage reduction) make sure the
common terminal Is connected to the earth terminal of the
-L
power source.
o Any Interruption of the protective (grounding) conductor
Earth terminal (sometimes used In manual to
Indicate circuit common connected to grounded
chassis).
(Inside or outside the Instrument) or disconnecting the
protective earth terminal will cause a potential shock
hazard that could result In personal InJury.
o Whenever It Is likely that the protection has been Impaired,
the Instrument must be made inoperative and be secured
against any unintended operation.
I
WARNING
I
The WARNING sign denotes a hazard. It
calls attention to a procedure, practice,
or the like, which, If not correctly
performed or adhered to, could result In personal Injury. Do
not proceed beyond a WARNING sign until the Indicated
conditions are fully understood and met.
o Only fuses with the required rated current, voltage, and
speCified type (normal blow, time delay, etc.) should be
used.
Do not use repaired fuses or short circuited
fuseholders. To do so could cause a shock or fire hazard.
'~
The CAUTION sign denotes a hazard. It
calls attention to an operating procedure,
practice,
or
the
like,
which,
If
not
correctly performed or adhered to, could result In damage to
o Do not operate the Instrument In th~ presence of flammable
gasses or fumes. Operation of any electrical Instrument in
such an environment constitutes a definite safety hazard.
or destruction of part or all of the product. Do not proceed
beyond a CAUTION sign until the Indicated conditions are
fully understood or met.
SC10984