Download K151/-K152/-K153 Avionics Standards GBAS

Avionics Standards
GBAS Configuration and Settings
Message Configuration Settings
Use the parameter LTP/FTP Height to define the altitude.
Table 4-3: LTP/FTP location configuration
Parameter
Description
"Position Format"
Sets the format in which the Latitude and Longitude are displayed.
●
"DEG:MIN:SEC"
The display format is Degree:Minute:Second and Direction, i.e.
XX°XX'XX.XX" Direction, where direction can be North/South and
East/West.
●
"Decimal Degree"
The display format is decimal degree, i.e. +/-XX.XXXXX°, where "+"
indicates North and East and "-" indicates South and West.
"Latitude"
Sets the latitude of the LTP/FTP in arc seconds.
"Longitude"
Sets the longitude of the LTP/FTP in arc seconds.
Remote command:
to enter the coordinates in Degree:Minute:Second format
[:SOURce<hw>]:BB:GBAS:VDB<ch>:MCONfig:LFLocation:COORdinates:DMS
on page 127
to enter the coordinates in decimal degree format
[:SOURce<hw>]:BB:GBAS:VDB<ch>:MCONfig:LFLocation:COORdinates:
DECimal on page 126
Delta_FPAP Location Configuration ← FAS Data Set
The Delta FPAD (ΔFPAD) represents the difference of latitude/longitude of the runway
Flight Path Alignment Point (FPAP) from the LTP/FTP.
The Delta FPAD coordinates are defined in WGS84 coordinates. In this coordinate
system, a location is identified by three coordinates, the altitude, the latitude and the
longitude. The last two can be displayed in decimal or DMS format. Use the parameter
"Position Format" to select the display format.
Operating Manual 1176.8600.02 ─ 05
38