Download Specifications

Maui Police Department
SVI Trucks Production Specification CO#3
RECEPTACLE FOR CAB TILT CONTROL
A receptacle shall be installed in the right hand side of the front bumper tail to provide a place to plug in the cab tilt remote
control pendant.
CUT OUT IN REAR CAB WALL
The rear wall of the 20" raised roof cab shall be cut out 24"W x 72"H for walk through application.
WHEEL WELL LINERS
Full width wheel well liners shall be installed on the extruded cab to limit road splash and enable easier cleaning. The twopiece liners shall consist of an inner liner 16" wide made of vacuum formed ABS composite and a outer fenderette 3.50"
wide made of 14 gauge 304 polished stainless steel.
EXTERIOR CAB ASSIST HANDLES
Three (3) 18" knurled anti-slip one-piece exterior assist handles shall be installed, one (1) behind each cab door. The
assist handle shall be made of 14 gauge 304 stainless steel and be 1.25" diameter to enable easy grabbing with the
gloved hand.
EXTERIOR PAINT
All cab painting must be completed prior to the installation of glass accessories or any other cab trim to assure complete
paint coverage and maximum corrosion protection.
The entire cab must be disc ground to remove any surface oxidation or surface debris that may hinder the paint adhesion.
After the surface is machine finished a high quality acid etching base primer shall be applied. Upon the application of
required body fillers and their preparation, the cab shall be primed with a coating designed for corrosion resistance and
surface paint adhesion. The entire cab then shall be coated with an intermediate solids or epoxy surfacer that is designed
to fill minor surface defects, provide an adhesive bond between the primer and the paint, and improve the color and gloss
retention of the color coats.
The cab shall be finish sanded with 360 grit paper, seams sealed with SEM seal sealer and painted with two (2) to four (4)
coats of an acrylic urethane type system designed not only for color retention, but to resist acid rain and most atmospheric
chemicals found on the fire ground or emergency scene.
The maximum overall film thickness of the top coat shall not exceed five (5) mils.
The standard PPG (FBCH) paint shall be warranted for ten (10) years against cracking, checking or peeling and loss of
gloss caused by chalking or fading, other paint warranties will vary by manufacturer (for example, Sikkens FLNA or Dupont
Imron 6000).
Cab underside and doors shall be rustproofed with a ten (10) year or 100,000 mile warranty certificate against perforation
issued in the Fire Department's name.
Cab to be painted White #___________.
Paint brand and color:
HAND SAND AND BUFF FINISH
The base coat clear coat finish shall be power sanded and machine finished to achieve a flat finish on all "A" visual
surfaces.
SVI #603
03/27/07
Page 29 of 86