Download LEOPARD ERV™

Leopard ERVTM Installation/Service Manual
SYRUP MODULE REPLACEMENT
7. Place the syrup module onto the mixing body, press
down firmly while rotating the module counter-clockwise
by 90 degrees.
NOTE: Make sure that the syrup module is fully
engaged in the mixing body.
8. Line up the bottom edge of the PCB with the slot in the
base and push it down into place.
NOTE: You should hear a click when the PCB is properly seated.
9. Snap the assembly into the base.
NOTE: You should hear a click when the mixing body
snaps into place.
10. Make sure the connector is positioned below the motor
shell.
Publication Number: 620919579SER
- 24 -
© 2002-2014, Cornelius Inc.