Download GE Infrastructure Sensing

November 2004
Introduction
The Model XGS868 electronics enclosure includes one slot for
installation of an input/output option card. This slot is designated as
Slot 1, and a variety of option cards is available. In addition, every
Model XGS868 flowmeter includes two built-in analog outputs (A
and B) at terminal block J1, which is designated as Slot 0.
Proceed to the appropriate section(s) of this chapter to calibrate and/
or test any of the installed inputs and/or outputs. Refer to the Menu
Map in Figure 1-2 on page 1-11 as a guide in following the calibration
instructions in this chapter.
Note: The instructions in this chapter assume the use of IDM for
programming the meter. To program the meter with the
optional RCCU, refer to Appendix C, Remote Control
Communications Unit, in the Programming Manual. To
program the meter with PanaView, see Appendix D, PanaView
for IDM-Compatible Meters, in the Programming Manual
and/or the PanaView User’s Manual (910-211).
•
calibrating the Slot 0 and Slot 1 analog outputs - page 1-2.
•
calibrating option card analog inputs - page 1-5.
•
calibrating option card RTD inputs - page 1-7.
•
testing option card alarm relays - page 1-8.
•
testing option card totalizer outputs - page 1-9.
•
testing option card frequency outputs - page 1-10.
Note: Convention in this manual identifies any expansion slot as
Slot x, where x is a number from 0-2. Slot 2 is used only for
data logging or Modbus option cards.
See Chapter 1, Installation, and Appendix B, Data Records, in the
Startup Guide for a complete description of the available option cards
and the procedures for wiring them.
Calibration
1-1