Download Related Commands
Transcript
If the self-test failed, one or more error conditions have been detected. Refer to the next section "Reading the Error Register". Reading the Error Register Whenever the display's ERR annunciator is illuminated, one or more errors have been detected. A record of hardware errors is stored in the auxiliary error register. A record of programming and syntax errors is stored in the error register. To read the error record(s), press: Error _ The lowest numbered error and a description of the error is displayed. For example, a possible error message is: Use the right arrow key to view the entire message. When the error message has a 100-series numeric prefix (e.g., 105), it indicates a programming or syntax error. A 200-series prefix (e.g., 209) indicates a hardware error. Note When you get a hardware error (200-series prefix), run the self-test again. If you repeatedly get the error, the multimeter may need repair. If the ERR annunciator is still illuminated, more errors have been recorded. Repeat the above key sequence until all errors have been read and the ERR annunciator is no longer illuminated. When you have read all the errors, the error annunciator goes off. If you try to read another error, the display shows: You do not have to run self-test to get an error. The multimeter detects errors that occur while entering data, when changing functions or ranges, and so on. The multimeter beeps whenever it detects an error. Whenever you want to clear information (such as an error description) from the display and return it to displaying measurements, press: Clear Back Space Note You can also clear the display by repeatedly pressing the Back Space key Chapter 2 Getting Started 31