Download MAINTENANCE INTERVALS - Safety

128
Maintenance Section
Maintenance Access
SEBU8495-03
Maintenance Section
3. In order to close the engine access door, put the
retaining pin in the stored position.
4. Close the engine access door.
Maintenance Access
i03879812
i01961574
Access Doors and Covers
Cab Tilting
SMCS Code: 7301-506; 7301-509
SMCS Code: 7273-572; 7273-573
Engine Access Door
Note: A pinch point exists between the top of the
engine access door and the radiator guard. Keep
hands away from this area when you close the
engine access door.
Do not go beneath cab unless cab is empty and
support lever is engaged.
Failure to follow the instructions or heed the warnings could result in injury or death.
The engine access door is located on the back of
the machine.
Do not tilt the cab using an open door. The door
must be closed and latched when lifting the cab.
The door may become dislodged from its hinges
and may cause serious personal injury or death.
Tilting the Cab Upward
1. Park the machine on level ground.
Note: Empty the water tank (if equipped) before you
tilt the cab.
Illustration 119
g01019131
1. Pull the release lever (1) in order to open the
engine access door (2).
2. Lower the loader arms fully. If you tilt the cab
upward with the loader lift arms in the RAISED
position, you must engage the brace for the loader
lift arms. See Operation and Maintenance Manual,
“Loader Lift Arm Brace Operation” for the process
for engaging the brace for the loader lift arms.
3. Turn the engine start switch key to the OFF
position.
4. Place supports under the rear of the machine in
order to support the machine while the cab is tilted.
Illustration 120
g01019162
2. Move the retaining pin from the stored position
(3) and put the retaining pin in the locked position
(4). This will prevent the engine access door from
closing inadvertently.