Download MAINTENANCE INTERVALS - Safety

Transcript
152
Maintenance Section
Transmission Breather - Clean
SEBU7857-04
3. Clean the area around the valve stem for the tire.
5. Install the breather.
4. Remove valve stem cap (1).
i02503848
5. Measure the pressure of each tire with a tire
gauge. Add nitrogen gas if the pressure is low.
6. Install the valve stem cap on the valve stem.
Refer to the following additional information about
tire inflation:
• Operation and Maintenance Manual, “Tire Inflation
with Nitrogen”
• Operation and Maintenance Manual, “Tire Shipping
Transmission Oil - Change
SMCS Code: 3030-044
S/N: DBC1-Up
Hot oil and hot components can cause personal
injury. Do not allow hot oil or hot components to
contact skin.
Pressure”
• Operation and Maintenance Manual, “Tire Inflation
Pressure Adjustment”
Consult your Caterpillar dealer for further information
on the correct operating pressures and the correct
load ratings.
i02503846
Transmission Breather - Clean
SMCS Code: 3030-070-BRE
Refer to Special Publication, NENG2500, “Caterpillar
Dealer Service Tool Catalog” for tools and supplies
suitable to collect and contain fluids on Caterpillar
products.
Dispose of all fluids according to local regulations and
mandates.
S/N: DBC1-Up
Illustration 188
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.
g00923124
Illustration 189
g01250922
The transmission breather is located on the top of the
transmission at the right rear of the tractor.
(1) Differential drain plug
(2) Transmission drain plug
Use the following procedure to clean the breather:
Transmission drain plug (2) is located under the
tractor. Differential drain plug (1) is closer to the front
of the machine.
1. Clean the area around the breather.
2. Remove the breather.
3. Wash the breather in clean, nonflammable solvent.
4. Allow the breather to dry.
Note: Operate the machine until the transmission
oil is warm.
1. Park the machine on a level surface. Apply the
parking brake.