Download Currier_Thesis

Transcript
3.3. SPEED CONTROL
CHAPTER 3. CONTROL SYSTEMS
Figure 3.2: Block diagram showing implementation of speed controller.
The lookup function is based on a simple map of vehicle performance containing a
full-throttle acceleration curve, a full brake acceleration curve, and a zero throttle acceleration curve derived from experimental data. The vehicle was accelerated at full throttle
on nearly flat ground from zero to 15 m/s and then stopped using full brake. The test was
repeated allowing the vehicle to decelerate with zero throttle and zero brake in Low gear.
The Escape Hybrid exhibits a zero-throttle, zero-brake creep speed of approximately 2
m/s; to complete the map, the zero throttle acceleration from zero to 2 m/s was also measured. The vehicle speed for each test was obtained from the vehicle CAN bus and logged
to a file at 50 Hz. Each test was repeated in the opposite direction along to road to correct for bias due to road pitch. The data from each of the two runs was averaged and the
acceleration at each point was calculated using a two-point backwards difference. The
data was plotted as acceleration versus speed for each condition and a high order curve
fit was performed to provide smooth curves. The result, shown in Figure 3.3, is a map
approximating the acceleration performance at speeds up to 15 m/s. Higher speeds were
not tested due to test space limitations, but were not required for this application as the
maximum required autonomous speed required is 13 m/s. The performance data is not
exact, but does provide a reasonable estimate of the vehicle’s capabilities.
The map lookup function performs a linear interpolation on the map at the current
speed to output the required throttle or brake to produce the desired acceleration. The
41