Download Service Manual

BRAKE - REAR DRUM BRAKE
(d)
(e)
(f)
BR–34
Hook the tension spring to the brake shoe (rear side), and
install the rear brake strut kit.
Install the rear brake shoe return spring from the back side of
the brake shoe.
Install the brake shoe (front side) with the rear brake shoe hold
down spring cup, the rear brake shoe hold down spring, and the
rear brake shoe hold down spring pin.
C137755
(g)
6.
INSPECT REAR DRUM BRAKE INSTALLATION
(a) Check that each part is properly installed.
NOTICE:
• Check that the wheel cylinder boot is not damaged, and
that there is no oil or grease on the part.
• Check that there is no oil or water on the surface of the
shoe lining.
7.
INSTALL REAR BRAKE DRUM
8.
ADJUST CLEARANCE BETWEEN BRAKE DRUM AND LINING
(a) Using a screwdriver through the service hole, extend the
adjuster by turning it. Extend the adjuster until the brake shoe
comes into contact with the drum.
C136078
Adjuster
Using the SST, install the tension spring to the brake shoe
(front).
NOTICE:
Do not damage the wheel cylinder boot.
Expand
C102598J01
(b)
(c)
Using another screwdriver, lift up the automatic adjust lever.
Then turn the adjuster until the drum rotates slightly.
Install the hole plug.
Adjuster
Retract
Automatic Adjuster Lever
C102597J01
BR
TO INDEX
TO NEXT SECTION