Download Mod: E77/4SPA7-N

3.
POSITIONING AND HANDLING
Removal of protection materials
The outer surfaces of the appliance are protected by a coating of adhesive film, which must be manually removed once
positioning phase is over.
Clean the appliance manually removing all the material used to protect its parts.
Make sure not to damage the stainless steel surfaces, and remember especially not to use corrosive
products, abrasive material or sharp tools.
Do not clean the appliance with pressurized and/or direct water jets.
Do not use aggressive materials such as solvents to clean the appliance.
Carefully read the indications on the label of the detergent products being used, wear a protective equipment suitable to the operations to be carried out (See protection means indicated on the label of the
packaging)
Rinse the surfaces with tap water and dry them with an absorbent cloth or other non abrasive material.
Levelling and fixing
Position in the working area (see allowed operational and environmental
conditions), with the different equipments already made suitable.
Levelling and fixing envisage: the equipment adjustment as an individual
independent unit or, if foreseen, its fixing in a "series".
The series positioning sequence for the different equipments
is strictly connected to the purchaser (user) requirements.
D
Position a level on the structure (detail D).
Adjust the levelling feet (detail E) according to the indications shown by the
level.
The appliance is perfectly levelled when level and feet are
adjusted on the same width and depth of the appliance.
E
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
- 11 -