Download Standard Bus Procurement Guidelines

Transcript
Standard Bus Procurement Guidelines
(Vehicle weight = GVWR, 50-State Power Plant)
SPEED
(MPH)
5.2.1.5
TIME
(SEC)
10
5.0
20
10.8
30
20.0
40
31.0
OPERATING RANGE
The operating range of the coach run on the design operating profile shall be at least 350 miles
with full fuel capacity.
5.2.2
5.2.2.1
5.2.2.1.1
DRIVETRAIN
POWER PLANT
Engine
The HHDD engine shall be designed to operate for not less than 300,000 miles without major
failure or significant deterioration. Components of the fuel injector and/or control system shall
be designed to operate for not less than 150,000 miles without replacement or major service.
Mileage intervals are based on the design operating profile defined in Section 5.1.2.
The engine shall meet all requirements of Part 5: Technical Specifications when operating on
Nos. 1 or 2 diesel fuel, as certified by the engine manufacturer and specified by the Procuring
Agency. Durability of the engine and its components shall not be seriously reduced and the
requirement of Section 5.2.2.5.1 shall be met by operation on either of the commercially
available diesel fuels.
The engine shall be equipped with an electronically controlled management system, compatible
with multiplex wiring systems and either 12- or 24-volt electrical systems. The engine control
system shall be capable of receiving electronic inputs from the engine and other vehicle systems.
Communication between these electronic systems shall be made using the SAE J1939
Recommended Practice communication link. The engine's electronic management system shall
monitor operating conditions and provide instantaneous adjustments to optimize both engine and
bus performance. The system shall have the capability of being programmed, allowing the
Procuring Agency to optimize engine performance. Initial performance settings shall only be
Technical Specifications
18
1/22/08