Download Standard Bus Procurement Guidelines

Transcript
Standard Bus Procurement Guidelines
5.4.4.4.6
Fastening
Interior panels shall be attached so that there are no exposed unfinished or rough edges or rough
surfaces. Panels and fasteners shall not be easily removable by passengers. Interior trim
fasteners, where required, shall be rivets or cross-recessed head screws.
5.4.4.4.7
Insulation
Any insulation material used between the inner and outer panels shall be sealed or self-sealing to
minimize entry and/or retention of moisture. Insulation properties shall be unimpaired during
the service life of the bus. Any insulation material used inside the engine compartment shall
not absorb or retain oils or water and shall be designed to prevent casual damage that may occur
during maintenance operations. All insulation materials shall comply with the Recommended
Fire Safety Practices defined in FTA Docket 90, dated October 20,1993.
The combination of inner and outer panels on the sides, roof, wheelwells and ends of the bus,
and any material used between these panels shall provide a thermal insulation sufficient to meet
the interior temperature requirements of Part 5: Technical Specifications. The bus body shall be
thoroughly sealed so that the operator or passengers cannot feel drafts during normal operation s
with the passenger doors closed.
5.4.4.5
FLOOR COVERING
The floor covering shall have a non-skid walking surface that remains effective in all weather
conditions and complies with all ADA requirements. The floor covering, as well as transitions
of flooring material to the main floor and to the stepwell area, shall be smooth and present no
tripping hazards. The standee line shall be at least 2 inches wide and shall extend across the
bus aisle. This line shall be the same color as the edge of the steps. Color shall be consistent
throughout the floor covering. Color and material of the floor covering is defined in attachment
to Part 5: Technical Specifications.
The floor in the operator's compartment shall be easily cleaned and shall be arranged to
minimize debris accumulation.
A one-piece center strip shall extend from the vertical wall of the rear settee between the aisle
sides of transverse seats to the standee line. The covering between the center strip and the wheel
housings may be separate pieces. At the rear door, however, a separate strip as wide as the door
shall extend from the center strip to the top step.
The floor under the seats shall be covered with smooth surface flooring material. The floor
covering shall closely fit the sidewall cove or extend to the top of the cove.
Technical Specifications
48
1/22/08