Download Foreword

CAUTION
REAR SEAT(S)
Always ensure that the seat belt is not trapped in
the release lever or any other vehicle part.
is folded past the vertical position. If the lever is
released early the seat will go into Easy entry
mode, see “Easy entry to the 3rd row (7-seater)”
later in this section.
3. Fold the seat forward.
To return the 2nd row outer seat to the seating position, pull and hold the lever j
2 up to push the
seatback up until it locks into position. Pull the lever
again to set the angle of the seatback as desired.
Pull the head restraint into the correct position for
the occupant using the seat.
NPA928Z
5–seater
NPA977
Folding (5-seater)
The luggage compartment loading capacity can be
increased by folding the rear seats forward.
To fold the seat:
1. Insert the side seat belt tongue into the slot located on the rear door pillar j
1 as illustrated.
2. Release the seatback lock by pulling on the latch
j
2.
3.
3. Fold the seat forward j
Adjustment 2nd row (7-seater)
Pull the lever j
1 up while you slide the seat forward
or backward to the desired position. Release the
lever to lock the seat in position. Rock the seat to
check the slides have locked. Pull the lever j
2 to
set the angle of the seatback as desired.
NPA978
Folding 2nd row (7-seater)
To fold the outer seats:
To fold the centre seat:
1. Make sure the seat belt is clear of the seat latch
mechanism.
1. Push the release button of the head restraint and
push the head restraint down. See “Head
restraints” later in this section.
1. Push the release button of the head restraint and
push the head restraint down. See “Head
restraints” later in this section.
2. Lift the seatback up and push firmly onto the
latch.
2. Release the seatback lock by pulling the lever j
2
up. The lever must be held up until the seatback
2. Make sure the seat belt tongue of the centre seat
is in the store position, see “Fastening the seat
belts” later in this section.
To return the seat to an upright position:
3. If the red lock tab is visible then the seat has not
latched properly — release and then re-latch the
seat.
3. Release the seatback lock by pulling the strap
j
1.
Safety — seats, seat belts and supplemental restraint system
1-3