Download Model 4181M Chart recorder User guide - E

Transcript
180 MM MULTIPOINT RECORDER INSTALLATION AND OPERATION MANUAL
3.2.2 Chart control page
Operator : Select a category
DISPLAY
CHART ALARM CHANNEL
MORE>
Operation of the CHART softkey calls the menu page depicted below.
Chart: Select a category
ON/OFF SPEED
LOG INT
MODE
SCALES
ON/OFF SOFTKEY
Operation of this soft key calls the chart on-off line page. With the chart on-line, the page is as depicted below.
Printer is On line
OFF FAST OFF
OFF
FAST OFF
If the OFF softkey is operated, the recorder will continue to print logs and queued demand messages before
printing a Printer Off message and then switching the chart drive off-line. After a ‘Please Wait’ message,
the display changes to the off line display, with a ‘Printer Off’ status indicator towards the right-hand end
of the display (inverse ‘P’).
If the FAST OFF softkey is operated, the recorder will finish printing the current line of text (if any) before switching the chart off-line. Demand messages are lost, but if logging is in operation when FAST
OFF is operated, the remainder of the log will be printed when the chart is switched back on-line.
Printer is Off line
ON PARK ADVANCE
P
ON
Switches the chart and print mechanism on. After a ‘Please Wait’ message, the display changes to the 'Online’ page shown above and the ‘Printer Off’ status indicator is extinguished.
PARK
Causes the printhead to move to the centre of the chart. Charts and printheads should be changed only with
the carriage parked in this way.
Operation of this key causes the chart to advance 16 cm. Once initiated, this advance cannot be stopped.
Further operations of the softkey during advance will cause further chart advances to be queued.
ADVANCE
SPEED SOFTKEY
Operation of the SPEED softkey allows the operator to switch between two chart speeds, known as chart speeds A and
B, set up during chart configuration as described in section 4.3.
Chart speed is 120 mm/hr : Speed
120
1200
Chart speed is 1200 mm/hr : Speed
120
1200
A
B
The current chart speed is shown in the top line of the display. Chart speed A (120 mm/hr in the example above) is
selected by operation of the left-most soft key; speed B (1200 mm/hr) by operation of the adjacent softkey.
HA247645
Issue 9 Jly 98
Section 3
Page 3 - 9