Download THE TECHNICIANS NOTEBOOK

Transcript
KN-62/62A/64Technician's Notebook
THE "SNIFFER"
ITEM
C-1
CK-1
J-1
J-2
R-I
R-2
R-3
R4
DESCRIPTION
Capacitor Mica 18 pf.
D i d c HP-2303
Jack, Subminiature
Jack, BNC
Resistor 62, 'Aw 5%
Resistor 270, '/rw
5%
Resistor 62, Xw 5%
Resistor 3.3K, '/lw5%
ASSEMBLY:
1 Assemble in a small box. (An old KN 65A tube assembly works well) malung a l l leads as short as possible. Use
minimum heat in soldering CRI.
2. The output is connected through duelded cable to the oscilloscope vertical input. The d.c. level (c.w.), or peak voltage
(pulsed r.f.) is indicative of the r.f input
3. The input may be directly connected through coax to low level r.f. inputs (less than a few watts c.u7.or several hundrcd
watts pulsed).
4. For stripline use, a pickup loop may be used. Form the end of a subminiature cable into a 1/4" diameter Imp, soldering
the center conductor to the sheld. We suggest the cable length be one wave length which is 7 5/8" (19.3cm) of RG
188N. The pigtail from a KN 65A ande assembly would be suitable. IMPORTANT NOTE: Be sure the entire loop is
wcll insulated, by tape or sllrink tubing.
USE:
1. You can measure c.w, of as low as 2-3 mw by measuring the d.c. voltage on the output. Pulsed power can be measured
by measuring the peak voltage seen on the oscilloscope. This is NOT intended to be, and CANNOT be, an accurate
measurement device. Useful comparisons may be made between g d radios and bad radios. It may be uscd for tuning
Purposes by tuning the asse~rlblyunder test for maximunl dclccted output and for a flat pass band response rluoughout the
DME band.
2. To use it with stripline circuits, use h e pick-up Imp and hold the loop parallel to the surface of the path. Move thc loop
along the path to find the point of maximum coupling. Since the exact voltage induced varies wilh many factors, this 1s
mostly a " GO/NO GO" test to l m t e the dcad transistor, switching Q d c , or circuit branch.
3. fitting a 50 ohm termination resistor across the output will make the output wave form more accurate, but
cannot
l
x used for measuring rise and fall timcs. A 50 .ohm termination also increases the amount of power the &odc mug
&ssipate, making it more easily damaged. The Output vollage secn by the oscilloscope will be grcatly reduced as well.
4. Excesslvc input can burn out llie detector diode. Too much average power (such as a transponder with 7777 and 1200
repliedsec), or too much peak voltage (such as grcatcr than 100-200 watts) may excecd thc limits of Lhc d i d .
NOTES: Don't forget to chcck the regulators on the mdulator hard: 5Volt 1- I02 and 9%Volt 1-103. Fuse in the front
panel. 3 A (03640058-0003) Display (037-000564N4lO).