Download 1973 E-2035RC-A
Transcript
10-5 ( 3. Hold the eccentric shaft with holding tool or spline wrench and torque flywheel nut with torque wrench and OMC Tool No. 318541 as shown in Figure 10-16. Adjusted torque reading with special tool used in this manner is 75-93 it. Compound Ibs. Use Loctite Retaining #40. 4. Install the transmission belt idler bearing on eccentric shaft. 5. Use Lubriplate 907 (OMC Part No. 114154) to lightly coat splines and retain neutral lockout balls in holes. 6. Place primary spring on shaft with closed side of spring cup toward bearing. 7. Install the two neutral lockout steel balls. .Figure 10-16 8. Install the primary spring, the sliding sheave assembly, and hold in place using the special tool, OMC Tool No. 263308. 9. Install end cap assembly on eccentric shaft spline. Insert the plunger and rod assembly and end cap bolt and thread into the eccentric shaft. Tighten the end cap bolt to 95 ± 5 ft. lbs. 10. Install the lock plate and lock plate screws. If serrations do not allow alignment of holes in lock plate and end cap, turn lock plate over and rotate until aligned position is obtained. 11. Operate the neutral lockout plunger to see that it functions prop erly. When neutral lockout is pushed in, the sliding sheave must not slide on spline. When neutral lockout is out (normal operating position) the sliding sheave must slide freely on spline restricted only by the primary spring. 12. Reconnect air intake duct and replace screws in instrument panel. 13. Replace transmission belt and belt guard. See Page 10-2. 14. Replace reverse shift rod, using same number of turns on the clevis as used in disassembly. Operate shift control. If adjustment is necessary see "SHIFT CONTROL ROD ADJUSTMENT." 15. Replace neutral lockout bracket on chain case. DRIVE CHAIN LUBRICATION The drive 'chain and sprockets are lubricated by the chain running through an oil bath. Check oil level by removing oil level plug in the bottom of the chain case. Lubricant level should come up to bottom of oil level hole. Remove rubber plug and fill with Dexron ATF Lubricant. It will hold approximately 4o·z . Replace plugs. See Figure 10-17. ADJUSTMENT Chain adjustment must be done with transmission in forward position. Total slack must be 1/ 4" ± 1/ 16". See Figure 10- 18. CHAIN ADJUSTMENT INSTRUCTIONS Rotate secondary drive pulley clockwise as seen from left side of machine until all slack in the chain is transmitted toward right side of chain case. Hold secondary pulley securely in clockwise position while cheCking chain adjustment. Remove chain inspection plug. Outer edge of chain should line up with left hand edge of hole. See Figure 10-17. Figure 10-17