Download 1.29 JAKE BRAKE®

Transcript
1.29
JAKE BRAKE®
4. Inspect slave piston components for excessive wear or damage.
[a] If worn or damaged, replace slave piston component.
[b]
If not worn or damaged, proceed with inspection.
5. Inspect the control valve bore for wear or damage.
NOTE:
Some wear marks are permissible.
[a] If worn or damaged, replace the housing.
[b]
If not worn or damaged, continue with inspection.
6. Inspect adjusting screw for excessive wear or damage.
[a] If worn or damaged, replace adjusting screw.
[b]
If not worn or damaged, proceed with inspection.
NOTE:
Model 790 Jake Brake® uses a J-Lash™ assembly. Model 795 Jake Brake® uses
a solid screw.
7. Inspect capscrews for excessive wear or damage.
[a] If worn or damaged, replace capscrews.
[b]
If not worn or damaged, proceed with inspection.
8. Inspect spacer tubes for excessive wear or damage.
[a] If worn or damaged, replace spacer tubes.
[b]
If not worn or damaged, proceed with inspection.
9. Inspect locknuts for excessive wear or damage.
[a] If worn or damaged, replace locknuts.
[b]
If not worn or damaged, proceed with inspection.
10. Inspect solenoid for excessive wear or damage.
[a] If worn or damaged, replace solenoid.
[b]
If not worn or damaged, proceed with inspection.
11. Inspect solenoid bore for excessive wear or damage.
[a] If worn or damaged, replace solenoid.
[b]
If not worn or damaged, proceed with inspection.
All information subject to change without notice.
1-582
From Bulletin 2-60-01Rev.
6SE483 0010 Copyright © 2001 DETROIT DIESEL CORPORATION