Download Maquet Servo -i Computer Interface Emulator

SERVO-i / SERVO-s, Computer Interface Emulator
8.5
Reference Manual
Reference Manual – Revision 07
8.5.1 History table – Revision 07
In the table below, the following keywords are used in ‘Comment’ column:
 Added. New functionality added with System version 4.0.
 Changed. Changed functionality e.g. due to System version 4.0.
 Corrected. Corrections made due to printing errors or lack of information in the previous version of the
Reference Manual.
Page
4
5
7
Section
Comment
General information
1. Introduction
About SV 300 compatibility
Text changed due to System version 4.0.
Text changed due to System version 4.0.
Corrected: Number of commands with emulated
response.
Added: Extended Alarm.
Corrected: AT and ST deleted (not available).
Corrected: Error descriptions in tables and table
notes.
Corrected: % in channel 103.
Added: Channel 119.
Corrected: % in channel 225.
Changed: Note 4 in channel 246.
Added: Channels 259 – 260.
Changed: Note 4 in channels 313 and 314.
Corrected: % in channels 316 and 317.
Corrected: Parameter name on channel 322.
Changed: Channel 330 activated.
Added: Channels 363 – 367.
Corrected: Information in the table clarified.
Added: Channel 363.
Added: Channels 444 – 446.
Added: Alarm status information/tables.
Changed: Note regarding standby mode and
trigger_point.
Corrected: SERVO-i / SERVO-s output syntax.
Changed: Note regarding standby mode and
trigger_point.
Changed: Note regarding standby mode and
trigger_point.
Changed: Note regarding SDADE.
Added: New RADA command.
Corrected: Breath Channels syntax.
Corrected: Settings and Alarm Channels syntax
deleted (not available).
Corrected: Introduction clarified.
Added: Extended alarm data output syntax.
Added: Alarm data extended syntax.
Added: Parameters, value 2.
8
9
11-12
4.3.1 Definitions
4.3.3 Common acronyms
4.6 Error handling
14
15
16
16
17
17
17
18
18
19
20-22
22
24
25
28
4.8.2 Channel 100-199
4.8.2 Channel 100-199
4.8.3 Channel 200-299
4.8.3 Channel 200-299
4.8.3 Channel 200-299
4.8.4 Channel 300-399
4.8.4 Channel 300-399
4.8.4 Channel 300-399
4.8.4 Channel 300-399
4.8.4 Channel 300-399
4.8.5 Switch Parameters for Channels 300-399
4.8.5 Switch Parameters for Channels 300-399
4.8.6 Channel 400-499
4.8.6 Channel 400-499
5.12 Read Curve RC
30
32
5.18 Trend Output TO
5.19 Ultra Curve RC
36
6.5.1 Curve Data
37
37
38
38-40
41
41
42
44
60
6.5.4 Alarm Data
6.5.5 Alarm Data with extended output
6.5.6 Trend Data
6.5.6 Trend Data
6.6 Read Acquired Data Continuously RADC
6.6 Read Acquired Data Continuously RADC
6.6 Read Acquired Data Continuously RADC
6.8 Read Alarm Output RALO
Revision 09