Download STR-W777
Transcript
SECTION 4 ELECTRICAL ADJUSTMENT TUNER SECTION 0dB=1µV Note 1: As a front-end (FE1) is difficult to repair if faulty, replace it with new one. Note 2: No adjustment is needed for a tuner pack except for AEP, UK, East European, CIS models. AM Tuned Level Adjustment (AEP, UK, East European, CIS model) Note: FM Tuned Level Adjustment should be performed after this AM Tuned Level Adjustment. Setting: Band: MW loop antenna (Supplied accessories) loop antenna AM RF SSG set AM antenna terminal (TM1) 60cm 30% amplitude modulation by 400Hz signal Field strength dB (µV/m) = SSG output level dB (µV/m) –26dB. Modulation: 999 kHz (at 9 kHz step) 1,050 kHz (at 10 kHz step) Procedure: 1. Set the output of SSG so that the input level of the set becomes 55 dB. 2. Tune the set to 999 kHz or 1,050 kHz. 3. Adjust RV41 to the point (moment) when the TUNED indicator will change from going off to going on. Adjustment Location [TCB BOARD] (Component Side) TM1 RV41 AM Tuned Level Adjustment Location: TCB board FM Tuned Level Adjustment (AEP, UK, East European, CIS model) Note: This adjustment should be performed after the AM Tuned Level Adjustment. Setting: Band: FM RV42 FM Tuned Level FM RF SSG 75 Ω coaxial IC21 set Carrier frequency: 98MHz Modulation: AUDIO 1kHz, 75kHz deviation (100%) Output level: 25dB (at 75 Ω open) FM ANTENNA terminal (TM1) Procedure: 1. Supply a 25 dB 98 MHz signal from the ANTENNA terminal. 2. Tune the set to 98 MHz. 3. Adjust RV42 to the point (moment) when the TUNED indicator will change from going off to going on. Adjustment Location: TCB board — 10 —