Download STR-W777

Transcript
SECTION 4
ELECTRICAL ADJUSTMENT
TUNER SECTION
0dB=1µV
Note 1: As a front-end (FE1) is difficult to repair if faulty, replace
it with new one.
Note 2: No adjustment is needed for a tuner pack except for AEP,
UK, East European, CIS models.
AM Tuned Level Adjustment
(AEP, UK, East European, CIS model)
Note: FM Tuned Level Adjustment should be performed after this
AM Tuned Level Adjustment.
Setting:
Band: MW
loop antenna
(Supplied accessories)
loop antenna
AM RF SSG
set
AM antenna
terminal (TM1)
60cm
30% amplitude
modulation by
400Hz signal
Field strength dB (µV/m) = SSG output level dB (µV/m) –26dB.
Modulation: 999 kHz (at 9 kHz step)
1,050 kHz (at 10 kHz step)
Procedure:
1. Set the output of SSG so that the input level of the set becomes
55 dB.
2. Tune the set to 999 kHz or 1,050 kHz.
3. Adjust RV41 to the point (moment) when the TUNED indicator
will change from going off to going on.
Adjustment Location
[TCB BOARD] (Component Side)
TM1
RV41
AM Tuned Level
Adjustment Location: TCB board
FM Tuned Level Adjustment
(AEP, UK, East European, CIS model)
Note: This adjustment should be performed after the AM Tuned
Level Adjustment.
Setting:
Band: FM
RV42
FM Tuned
Level
FM RF SSG
75 Ω coaxial
IC21
set
Carrier frequency: 98MHz
Modulation:
AUDIO 1kHz, 75kHz
deviation (100%)
Output level:
25dB (at 75 Ω open)
FM ANTENNA terminal (TM1)
Procedure:
1. Supply a 25 dB 98 MHz signal from the ANTENNA terminal.
2. Tune the set to 98 MHz.
3. Adjust RV42 to the point (moment) when the TUNED indicator
will change from going off to going on.
Adjustment Location: TCB board
— 10 —