Download Edge Evolution Programmer Installation Instructions

Evolution
Ford 6.0 Liter
Connect the male
connector end of
the EGT Probe to
the OBDII
connector
Installing the Evolution
The Evolution programmer connects to the diagnostic port of your vehicle.
Follow these steps to install the Evolution:
1. Begin by removing the access panel that is located just below the steering
wheel (figure #1). Turn your ignition key to the OFF position.
Figure #1
2. Locate the black diagnostic (OBDII) connector (Figure #2) under the dash
on the bottom right corner of the access panel area. As you sit in your
vehicle, it could be located right below your right knee. Sometimes the
cover to this connector will be labeled “Data link.”
13