Download Covers - Permobil

Fuses
Fuses
For this task the following tools are necessary:
1
1
Assembly Assemble in the reverse order.
Wrench 6 mm.
Phillips head screwdriver
1. Switch the new main fuse to OFF.
2. Connect the cables to the new main fuse.
m CAUTION!
Note the direction in which the fuse is installed for subsequent
fitting. The ON/OFF position must match the appropriate
sticker on the chassis.
Check that the cables are firmly attached.
Main fuse cable connection.
3. Fit the new main fuse on the bracket with the two nuts (see fig. below).
4. Reattach the battery connection cables to the batteries.
5. Fit the chassis covers. See page 8-9.
On chassis with VR2 Control System the
Main Fuse is fitted with two nuts.
On chassis with R-net Control System the
Main Fuse is fitted with two nuts.
6. Switch the main fuse to ON (see fig.).
Off
On
Main fuse/battery isolator (On/Off).
51