Download StorageWorks Network Array Service Manual

Transcript
Configure Storage for the Second HS1CP
When you add a second HS1CP and/or StorageWorks storage devices to the
network array, you must configure the storage system to meet your particular
storage needs.
Appendix B in the StorageWorks Network Storage Array Installation Guide
provides a detailed description of stripesets and RAIDsets you can configure for
the network array. It also provides rules for configuring the storage devices.
When you are configuring the storage devices connected to a second HS1CP for
redundancy, both HS1CPs must have the same storage configuration. Follow the
procedure below to copy the storage configuration from the original HS1CP1 to
the newly installed HS1CP2.
1. Make sure you have a terminal connected to the newly installed HS1CP2 as
described in Section 8.3.
2. Copy the configuration from HS1CP1 to the newly installed HS1CP2 with the
following command:
HS1CP2> SET FAILOVER COPY = OTHER
3. Restart the newly installed HS1CP2 by entering the following command on
the terminal connected to the HS1CP2:
HS1CP2> RESTART THIS
These messages appear on the screen:
%PAx0, Software is Closing Virtual Circuit -- REMOTE NODE HS1CPx
%HSCPAD-F-NOLOCEXE, Local program not executing
-SYSTEM-F-VCBROKEN, virtual circuit broken %HSCPAD-S-END, Control
returned to node
4. Enable the path from the HS1CP to the server processor by entering the
following command:
HS1CP2> SET THIS_CONTROLLER PATH
You have completed the configuration procedure and are ready to save the
storage configuration.
Removing and Replacing Field Replaceable Units 8–51