Download 2016 Lyrik

25
RCT3: Use a 2.5 mm hex wrench to thread the low speed
compression needle into the bladder assembly clockwise until
it stops, and then unthread it 1/4 of a turn.
4 mm
26
RCT3: Insert the low speed compression adjuster into the
compression cam assembly. Push down and turn the low
speed compression adjuster clockwise until it clicks into place.
RCT3
RC: Use needle-nose pliers to insert the bleed plug into the
compression adjuster until it clicks into place.
RC
27
Use retaining ring pliers to install the inner retaining ring into
the retaining ring groove.
Check that the retaining ring is properly seated in the
retaining ring groove by using the retaining ring pliers to
rotate the retaining ring and seal head back and forth a few
times.
RCT3: The low speed compression adjuster must be installed
properly for the retaining ring to be seated in its grove.
RC: The bleed plug must be installed properly for the retaining
ring to be seated in its grove.
Charger Damper™ Assembly and Bleed
45