Download 2016 Lyrik

33
RCT3: Thread the knob retaining nut into the compression
cam assembly.
6 mm
3.5-4.0 N•m (30-35 in-lb)
4 mm
4.0-5.5 N•m (40-50 in-lb)
While holding down the compression mode adjuster knob,
tighten the knob retaining nut. Turn the knob clockwise
through both clicks until it stops, and use a torque wrench
with a 6 mm socket to tighten the knob retaining nut to
3.5-4.0 N•m (30-35 in-lb).
NOTIC E
Make sure the knob retaining nut is not cross-threaded as it
can move the adjuster knob beneath it.
34
RC: Install the knob retaining nut. While holding down the
compression mode adjuster, use a torque wrench with a
4 mm hex bit socket to tighten the nut to
4.0-5.5 N•m (40-50 in-lb).
35
RCT3: Install the low speed adjuster knob and knob retaining
screw. Use a torque wrench with a 2 mm hex bit socket to
tighten the screw to 1.0-1.5 N•m (8-13 in-lb).
2 mm
1.0-1.5 N•m (8-13 in-lb)
Charger Damper™ Assembly and Bleed
48