Download PLC-XP18E SERVMAN
Transcript
NOTES ON SCHEMATIC DIAGRAM 1. PRODUCT SAFETY NOTICE - T - ! ! ^ COMPONENTS DESIGNATED BY A MARK ( A ) 'N TH)S SCHEMATIC D)AGRAM ) ! ! LiDESIGNATE COMPONENTS WHOSE VALUES ARE OF SPEOAL SIGNIF!CANCE TO PRODUCT SAFETY. SHOULD ANY COMPONENT DESiGNATED BY A MARK NEED TO BE REPLACED, USE ONLY THE PAFtT DES)GNATED )N THE PARTS DST. DO NOT DEVfATE FROM THE RESISTANCE. WATTAGE AND VOLTAGE RAHNGS SHOWN. 12. NOTES ON SCHEMADC DIAGRAM Specification of capacitor and resistors wi!i be shown with coded symbofs, reading code symbols foitowing the chart and notes. Some capacitor and resistors wi!i be shown directly with vaiues and no other information. Detailed information on each capacitor and resistor wi!) be shown in the !istNOTE; DO NOT REPLACE OR ORDER RESISTOR AND CAPACITOR PARTS FOLLOWING THE SPECIFICATIONS SHOWN [N THE SCHEMATA DIAGRAMS. ALWAYS CHECK FOR THE CORRECT SPECIFICATIONS iN THE PARTS UST. ESPECIALLY FOR CRITICAL COMPONENT MARKED ^ . SPECIAL ATTENTION MUST BE GIVEN TO CRITICAL COMPONENTS. 13. READING tN SCHEMATIC DIAGRAM Read resistor codes as foftows: 1. Afl resistance values are indtcated in ohms: K=1,000. M=1,000,000. 2. Resistor which is indicated with resistance vaiue only are 1/6W carbon resistor. Resistor which is indicated with materia) tolerance and vafue are 1/4W rated wattage. Read capacitor codes as foltows: 1. For capacitors identified with -()-, values !ess than 1 are expressed in uF, values more than 1 are in pF 2. For capacitors (electrolytic) identified with -^-, vafues are expressed in uF. Voltage and waveforms were taken using a video color bar signal (1V p-p at 75 ohms terminated) and controfs to normal. Vottages were taken with a high-impedance voftmeter. N 4. SERVICE NOTES: 1.When replacing high wattage resistors on circuit board, keep the resistor body 10 mm (3/8') from circuit board. 2. Keep wires away from high voftage and high temperature components. -50-