Download 700 Section 2 (28) Ignition systems
Transcript
Group 28 Ignition systems Design and function - Components c B Components Control unit The control unit in an electronic ignition system continuously computes the optimum tim i ng based on information supplied by the various sensors, which combine to provide the unit with an extremely accurate picture of engine running conditions. The con trol unit receives immediate notice of any change in the conditions under which the engine is powering the car, enabling it to compute a new setting instantaneously. Once this has been completed (in an operation taking as little as a thousandth of a second!), the unit delivers an ignition pulse to the power stage. The control unit consists of a number of electronic components. In simplified terms, these consist of four main elements - converter (A), memory (B), microprocessor (chip) (C) and output unit (D). Converter A. The converter (A) receives information from the sensors and converts the signals into digital (n umerical) form. Some of the sensors supply analogue signals (such as the temperature-dependent change in resistance typical of a temperature sensor), while the signal transmitted by others depends on whether or not a voltage is present (as in the case of a throttle switch). The sensors may also transmit signals in the form of voltage pulses (like an inductive pickup) or a variable-frequency voltage (like a load signal vacuum converter). All of these electrical signals, whet her in the form of a single, variable voltage or a series of voltage pulses, are converted into standard digital form by the converter, the outputs from which are used by the microprocessor and memory. Memory B. All programs and pre-programmed values are stored in the memory (B), in which all possible values of parameters such as engine load and speed are available for immediate use by the microprocessor. Micropro cessor c. The microprocessor (C) receives the digital signals from the converter. Depending on the signal configuration, the device selects the memory program which best meets the needs of the prevailing running conditions. 14