1
Download - Brunswick
Transcript
Figure 5-36. Check Pivot Bearing Clearance (1) VERIFY CLEARANCE (4) CRANK ARM (2) MAIN SWEEP ARM (3) PIVOT BEARING Below are some of the possible problems that can occur if the setting table is not at the proper heights in the Highest and Lowest positions. Pin Deck Position Setting Table Too 1. Setting table makes contact with lane surface. Close To Pin Deck 2. Pins wobble when set on lane. Setting Table Too 1. Weight of pin will not allow grippers to open to Far From Pin Deck release pins to the lane. Section Rev. August 2009 Section 5: Adjustments 5-31
