Download MAINTENANCE INTERVALS - Safety

Transcript
SEBU7764-10
185
Maintenance Section
Power Train System Screens - Clean
6. After you take a sample, remove the cap with the
tube and the probe from the bottle. Discard the
cap with the tube and the probe. Install the sealing
cap that is provided with 8T-9190 Fluid Sampling
Bottle.
Transmission
7. Replace the protective cap (4) for the sampling
valve.
8. To lower transmission guard (3), support the guard
with the proper lifting device.
9. Position handle (2) to area (B).
10. Lower the transmission guard. Install the lock
pin bolt, secondary bar pin and washer (1) to the
brackets.
Illustration 274
g02161128
1. Remove the plug from the drain valve in the
transmission cover (1). Install a 12.7 mm (.50 inch)
pipe with 1/2-14 NPTF threads into the valve.
11. Return handle (2) to position (A).
i03965189
Power Train System Screens
- Clean
SMCS Code: 3067-070
2. Clamp a hose to the pipe in order to drain the oil
into a suitable container.
3. Open the drain valve and drain the oil into a
suitable container.
4. Close the drain valve.
Hot oil and components can cause personal injury.
Do not allow hot oil or components to contact
skin.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared
to collect the fluid with suitable containers before
opening any compartment or disassembling any component containing fluids.
Refer to Special Publication, NENG2500, “Caterpillar
Tools and Shop Products Guide”, for tools and supplies suitable to collect and contain fluids in Caterpillar
machines.
Dispose of all fluids according to local regulations and
mandates.
Operate the machine in order to warm the power train
oil. The machine must be level. Lower the work tools
with slight down pressure.
When you change the transmission oil, clean the
scavenge screens.
5. Remove the hose and remove the pipe from the
drains.
6. Remove the bolts for the drain cover (2) and
remove the drain cover(3). Remove the seal and
remove the screen that is located behind the
cover.
7. Wash the screen in a clean, nonflammable
solvent.
8. Inspect the seal. If the seal is damaged, replace
the seal.
9. Install the screen, the seal, and the drain cover on
the transmission.
10. Clean the oil drain plug and install the oil drain
plug.
Suction Screen
The suction screen for the power train is located
below the cab.