Download Machine Manual

Operator’s Tour
FIGURE 2-7.
Identify Controls on the Six Shooter
About the Hopper
The Hopper sorts the screws for delivery to the screw gun. The Hopper is attached to the Frame
Interface which in-turn is attached to the Six Shooter.The Frame Interface allow the six shooter
assembly to move across the machine.
Screw
Tracking
Plate
Assembly
Gate Assembly
Hopper
Opt. Z Quick
Change Dump
Gate
Screw
Pick-Off
Cylinder
Opt. Z Quick
Change Dump
Cylinder and
Funnel
Screw Pick
Off Slide
Assembly
Plate Assembly
Cylinder
Opt. Z Quick
Change Dump
Container
Track Wheels
Screw Delivery Tubes
Air Injected
Hopper Cylinder
Six Shooter Pivot
Cylinder
Frame Interface
Six Shooter
FIGURE2- 8.
Hopper and Frame Interface
Important: Do not adjust any of the Hopper air cylinders. They are adjusted at the
factory. Any adjustment may cause timing issues with the operation of
the Six Shooter. If you think problems are being caused by the cylinders,
please contact the KVAL Service Department for direction.
2-10
KVAL 994-X Operation / Service Manual