Download Condensectomy booklet

Transcript
Procedure - overview
Having eased the drive-end end-piece away from the bobbin, you will be able to see whether the armature is
fitted with an original Lucas condenser (picture top right) or with a more modern device which is usually potted
in resin. The procedures to be adopted are roughly similar for both and summarised by the following schematics.
BEFORE
AFTER
IF FITTED WITH ORIGINAL
LUCAS CONDENSER
Original
condenser
removed
Lucas condenser and
mounting bracket
Drive-end
end-piece
Screw
Screw
LT live link wire
Heat-shrink
LT winding live end
LT winding
earth end
LT winding live end
Earth wire connected to
drive-end end-piece by
solder tag and screw
Solder tag
LT winding
earth end
LT live link wire
Two LT live wires soldered
together and insulated with
heat-shrink sleeving
Bobbin
HT spike
Nut for centre screw
and insulated mounting
CB-end
end-piece
Slip ring
Points
New EasyCap
Contact breaker
assembly
Centre-screw
IF FITTED WITH POTTED
NON-ORIGINAL CONDENSER
BEFORE
Resin and original
condenser removed
Drive-end
end-piece
Condenser
Solder tag
and screw
Screw
Resin
LT winding live end
Heat-shrink
LT winding live end
LT winding
earth end
LT live link wire
LT live link wire
Two LT live wires soldered
together and insulated with
heat-shrink sleeving
Bobbin
HT spike
Nut for centre screw
and insulated mounting
CB-end
end-piece
Slip ring
Points
New EasyCap
Contact breaker
assembly
Centre-screw
8
AFTER
Earth wire connected to
drive-end end-piece by
solder tag and screw
Solder tag
LT winding
earth end