Download Instructions manual

• Press
(maintenance menu appears on the display)
THE PELLET HEATING
SERVICE
F1
F2
F3
F4
C
E
=
=
=
=
=
=
Exhaust measure
PELL-SUCTION
HEAT E.CLEAN
WORM SCREW
BURNER GRATE
INDUCED DRAF
CONFIRM
WE 24.05.06
07:22:26
HEATING OFF
ON/OFF
ON
OFF
MENU
MESSAGE
PLEASE NOTE!
Do not operate the system before having read these instructions thoroughly!
• By pressing
the heat exchanger cleaning will start. Let it run for approx. 5 minutes in order to permit a deep
cleaning of the heat exchanger pipes. The procedure will be stopped by pressing again this key.
• Press
to open the burner grate; the ashes fall directly onto the ash drawer underneath.
• In order to prevent dust escaping while opening the boiler door, start the flue gas exhaustern by means of
ATTENTION:
If the display turns black (after approx. 10 minutes),
all aggregate units automatically switch off !ADVICE: If you wish to restart an
aggregate unit, start it again with the correspondent key!
• Open the covering door (or remove front cover) in order to have access to the burner cleaning door
38