Download Adjustments

Repairs
Adjustment of limit switch kit on
stand function actuator
The limit switch kit is located on the actuator. The
switches are aware of the position of the actuator
and send signals to the seat’s control system. The
limit switch kit must be adjusted after fitting
1. Raise the seat lift to it’s highest position.
2. On the seat lift, activate the switch that inhibits
the standing function by winding tape around
it, see fig.78.
Fig. 78. Activate the switch with tape.
3. Elevate the seat a little towards the standing
position, then lower the seat towards the sitting
position just enough to make the seat frame
rest on the spacers.
Fig. 79. In sitting position, the seat frame
rests on two spacers.
4. Mark the piston of the stand function actuator
with a pen, see Fig. 80.
Fig. 80. Mark the piston of the
stand function actuator.
33