Download SERVICE MANUAL

5 Peel the adhesive sheet (upper) that secures the main flexible board.
6 Disengage the main flexible board from the hook of the ring assembly, and then slide the main flexible board
to remove.
7 Peel the adhesive sheet (lower) that secures the main flexible board.
* The FOCUS motor must remain soldered.
6 Main flexible board
Hook
Ring assembly
5 Adhesive sheet (upper)
7 Adhesive sheet (lower)
Solder of FOCUS motor
8 Remove four screws that secure the rear assembly.
9 Remove the rear assembly, disengaging the bosses at four places.
* Take care not to get stuck with the vibration-proof flexible board.
q; Unhook the Z leaf spring to remove.
qa Remove the main flexible board from the ring assembly, and remove the rear assembly and the nuruto gear.
qa Nuruto gear
8 Four screws
Rear
assembly
Hook
9
q; Z leaf
spring
Boss
Ring assembly
Vibration-proof flexible board
Boss
Ring assembly
qa Rear assembly
qa Main flexible
board
DSC-W80/W85_L2
2-9