Download Maintenance Manual Change Tracking

Maintenance Manual > Operating Principle > Basic Operation > Main Switch Power OFF
Model CJV30/TPC Issued 2008.08.04 Revised 2008.09.17 F/W ver.
1.20
Rev.
Remark
1.1.8 Main Switch Power OFF
1.1
 Indication on LCD
 Display at sub switch power OFF
PLEASE WAIT
POWER OFF
1
 Processing sequence
 Processing during sub-power OFF
Step
Processing
Indication
on LCD
Description
1
Hardware resources OFF
1. Turn off the heater, dry fan, exhaust fan, and vacuum fan.
2. Turn off the output of the COM waveform.
2
Stand by head connecting unit
1. Move the head connecting unit to the print head for connecting.
3
Turning off solenoids
1. Turn off the Print head solenoid, clamp solenoid, and cartridge valve
solenoid.
4
Saving parameters
1. Save parameter values of system parameter, running parameter, etc.
2. Update head ID and Print head memory.
5
Setting up sleeve start-up time
1. Set the start-up time of operations executed during sub-power OFF
such as sleeve refresh, pump tube cleaning, and cleaning.
6
Motor OFF
1. Turn off servo and drive motor power.
7
Sub-power LED blinking
1. Indicates sub-power off by sub-power LED blinking.
8
Power OFF

3
4
5
 Processing during main-power OFF
Step
1
Processing
Saving parameters
2
Description
6
1. Save the running parameter values.
In service mode, the buzzer sounds when the parameter values have been stored successfully.
 Turn off sub-power to implement the sleeve operation for the prevention of the clogged ink during
power OFF.
7
 When turning off main power, turn off sub-power first and then main power.
8
WWW.SERVICE-MANUAL.NET
© 2009 MIMAKI ENGINEERING CO.,LTD.
1.1.8
R.1.1
P.1