Download KX-FL612CX KX-FL612CX-S

KX-FL612CX / KX-FL612CX-S
6.5.11.1. JOURNAL 2
Refer to JOURNAL 2 in PRINTOUT EXAMPLE(P.116).
Journal 2 displays the additional detailed information about the last 35 communications.
Descriptions:
(1) RCV. MODE
Indicates which receive mode the unit was in when the unit received a fax message.
This information is also displayed when the unit transmitted a fax message.
(2) SPEED
Indicates the speed of the communication. If multiple pages are transmitted or received, it indicates the last page’s
communication speed. If there is a communication error, “?” is displayed.
(3) RESOLUTION
Indicates the resolution of the communication. If multiple pages are transmitted or received, it indicates the last page’s
resolution. If there is a communication error, “?” is displayed.
(4) RCV-TRIG. (CNT.)
Indicates the trigger that causes the unit to switch to the fax receive mode. The available options are listed in JOURNAL 2 in
PRINTOUT EXAMPLE(P.116). The values in parentheses indicate how many times the trigger has been used. (For example,
“0003” means three times.)
No.
1
2
3
4
5
Display
FAX MODE
MAN RCV
RMT DTMF
PAL DTMF
TURN-ON
Means the
Means the
Means the
Means the
telephone.
Means the
unit
unit
unit
unit
Function
received a fax message in the FAX mode.
received a fax message by manual operation.
detected DTMF (Remote Fax activation code) entered remotely.
detected DTMF (Remote Fax activation code) entered by a parallel connected
unit started to receive after 10 rings. (Remote Turn On: Service Code #573)
(5) ERROR→
→MEMORY
Indicates the reason why the unit received a fax message in memory.
If you look at No.11 in the JOURNAL 2 in PRINTOUT EXAMPLE(P.116), it shows the fax message was received in memory
due to “PAPER OUT” error.
NO RESPONSE DISAPPEARED ON JOURNAL
The “NO RESPONSE DISAPPEARED ON JOURNAL” displays the information about the last 10 communications terminated
by “No Response”. (Some of the communications terminated by “No Response” were not displayed in the JOURNAL.)
When a fax transmission cannot be performed because the other party’s unit is set to the TEL mode, “No response” will be
printed.
115