Download Operator`s manual

Features, care, cleaning and maintenance
Calibration
If it is wanted to make a equipement calibration,
check software operator's manual available in http://
www.terragene.com.ar/productos/control-de-infecciones/control-de-procesos-de-esterilizacion/incubadoras/ic10-20fr/
Features, care, cleaning and maintenance
Time zone change
Cancel time zone change
Hours setting
3-To advance time, press TEMP button as many times
as hours you need to advance. To delay time press
SOUND button as many times as hours you need to
delay.
Advance
Delay
To cancel change time zone process and not save
changes, disconnect power source.
NOTE: Lights corresponding to 1 to 10 incubation/
reading positions indicate the digit value which is set.
Lights from 1 to 9 indicate digit value from 1 to 9. Light 10 indicates 0 value.
In time setting mode, light 1 from Pro sector will turn
on to indicate ten hour modification.
IMPORTANT: 24-hour format.
Time zone change mode
This function allows you to advance or delay the internal incubator clock in order to adopt a different
time zone.
Enter time zone change mode
1-De-energize the incubator.
NOTE: 37 °C light indicates a.m. and 60 °C light indicates
p.m.
Ten hours setting (Hh:mm)
3-The blue light number 1 corresponding to Pro sector should be on. If any other light from Pro sector is
on, press PRO button as many times as necessary to
turn on the blue light number 1. This indicates ten
hour setting.
Time setting mode
Time setting functionality allows you establish a specific time regardless of incubator current time.
a.m. p.m.
Enter time setting mode
1-De-energize the incubator.
2-Press and hold both TIME buttons simultaneously
and energize the equipment. A beep will be emitted
to indicate access to time zone change.
4-To increase ten hours value, press TEMP button. To
reduce ten hours value, press SOUND button. NOTE:
the possible values for ten hour are 0, 1 and 2.
Advance
Complete time zone change
Delay
4-To save changes press and hold PRO button for
three seconds. A beep will sound indicating that process has been completed successfully. A ticket with
the new set time will be printed.
2-Press and hold both TIME buttons and TEMP button simultaneously and energize the equipment. A
beep will be emitted to indicate access to time setting
mode.
NOTE: a green light will turn on in one of the incubation/reading position. This number corresponds to
the current incubator time.
IC10/20FR Page 12
Unit hours setting (hH:mm)
5-Press PRO Button to turn on the blue light number
2. This indicates unit hours setting. If any other light
from Pro sector is on, press PRO button as many times
as necessary to turn on the blue light number 2.
IC10/20FR Page 13