Download Manual de Usuario

Hardware
Installation
Installation Steps
ENGLISH
Read completely, then follow step-by step.
• The appliance shall be installed in accordance with national wiring regulation.
• If a power plug isn't to be used, provide a circuit breaker between power source and the unit, as following
picture.
Main Power source
Circuit Breaker
Use a circuit breaker
or time delay.
Select the Best Location
1. To prevent vibration and noise, make sure the unit is
installed securely and firmly.
AWNING
2. Install the unit where the sunlight does not shine directly on FOAM
the unit.
HEAT
RADIATION
COOLED
AIR
70-150cm
3. There should be no obstacle, such as a
fence or wall, within 50cm from the back of the cabinet
because it will prevent heat radiation of the condenser.
Restriction of outside air will greatly reduce the cooling
efficiency of the air conditioner.
FENCE
4. Install the unit a little obliquely outward not to leak the
condensed water into the room (about 10 ~ 15 mm or 1/4
bubble with level).
10~15 mm
Over 50 cm
1/4 Bubble
CAUTION: All side louvers of the cabinet must
remain exposed to the outside of the structure.
Level
Remove the Air Conditioner From the Case
1. Remove the 2 shipping screws from the back of the
case.
3. Slide the air conditioner from the case by gripping
the base pan handle and pulling forward while
bracing the case.
2. Remove the 2 screws on each side of the case.
Keep these for later use.
4. Before installing the Air Conditioner back into the
case, remove the white styrofoam shipping block
from the compressor (Applicable for some models).
Shipping screws
White styrofoam block
15