Download Sunlite 2006

Sunlite 2006
VI Annexes
DMX Boards
The Sunlite software can take input commands from DMX boards. Any button on the Sunlite screen can
be triggered through DMX, and also any fader can be linked to a DMX fader on a board. The following
sites will give you an idea of where to start looking:
www.proformance.net
DMX Dimmer Packs
Conventional lighting can be controlled through DMX if these fixtures are connected to what are known
as Dimmer Packs. There are many manufacturers out there.
www.proformance.net
3. IP/Ethernet configuration
Our Ethernet interfaces come with a factory IP address 192.168.1.20. An IP address is a number that is
unique to any particular device within a network. In order to communicate with your interface, you need
to manually set your computer’s IP address to 192.168.1.xx, where “xx” is any number other than 20.
You cannot have both devices (interface and computer) with the exact same IP address, but both need
to be within the same subnet (192.168.1.xx).
To configure your computer to work with our Ethernet interface:
1. Connect your IP/Ethernet interface to your computer and to its power supply (9-12V DC).
2. Change your computer’s IP address to match the interface's subnet mask. Start from Window’s
Control Panel, then Network Connections. Double-click on the Local Area Network connection, then
click on TCP/IP, then Properties. Change from “Automatic” to “Use the following” IP address, and type:
IP 192.168.1.xx (xx is any number larger than 10, different from 20)
Subnet mask 255.255.255.0
Leave all other fields blank, then click OK. Wait a few moments while the connection is reset between
the interface and computer. Close the Local Area Network properties window.
3. Start the Sunlite software.
Copyright © 2006 ~ Nicolaudie. All rights reserved.
Page 103