Download USER`S A UAL

Important
safet
1 5. POWER SOURCE:
label,
instructions
This TV should
be operated
only from the type of power source indicated
if you are not sure of the type of power
power company.
instructions.
16. POWER
For TVs intended
CORD PROTECTION:
on or pinched
to operate
receptacles,
Power-supply
and the point where
or cable system
your appiiance
power, or other sources,
dealer or locai
refer to the operating
cords should
be routed
so that they are not likely to be walked
them, paying
particular
attention
to cords at plugs, convenience
they exit from the appliance.
: if an outside
or cable system is connected
the antenna
from battery
by items placed upon or against
17. OUTDOORANTENNAGROUNDiNG
antenna
suppiy to your home, consult
on the marking
to the TV, be sure
is grounded
FIGURE
to provide
A
...... Z-
EXAMPLE OF ANTENNA GROUNDING AS PER
some protection
static
against
charges.
Section
Code, ANSi/NFPA
respect
voltage
810 of the National
NO.70,provides
to proper grounding
grounding
discharge
unit , size of grounding
electrodes,
electrode.
during
wall outlet
storm,
damage
LINES:
other electric
ELECTRIC
_-.-'_
/--,'
antenna
system,
extreme
"_
.... POWERSER",OE
OROUNO,NO
ELECTRODE SYSTEM
and unused for long periods
of time, unplug
it from the
or cable system.
system
and power
line surges.
should not be located
or where
careshould
contact with them might be fatal.
20. OVERLOADING:
Do not overload
.-
GRODNOCLAMPN
$2898A .....
for this TV receiver
to the TV due to lightning
An outside
antenna
'_
SERVICE
......
for the grounding
light or power circuits,
ANTENNA
.k.-
i_ ........ DINCRAROEUNIT
to grounding
the antenna
,
,
i:
location
or when it is left unattended
and disconnect
This will prevent
outside
wire to an antenna
NG: For added protection
INWIRE
"-..
.......
a lightning
19. POWER
CLAMP
(Fig.A)
18. LIGHTNi
ANTENNA LEAD
::4"
with
conductors,
unit, connection
and requirements
7: :----"_
CODE
Electrical
information
of the lead-in
discharge
NATIONAL ELECTRICAL
of the mast and supporting
structure,
of antenna
surges and built-up
wall outlets
in the vicinity
it can fall into such power
be taken to keep from touching
and extension
of overhead
lines or circuits.
power lines, or
When installing
an
such power lines or circuits
as
cords as this can result in a risk of fire or electric
shock.
21. OBJECT
AND L IQU ID ENTRY:
touch dangerous
voltage
points
Never push objects
or short out parts
of any kind into this TV through
openings
that could result in fire or electric
shock.
as they may
Never spill liquid
of any kind into the TV.
22. SERViCiNG:
dangerous
Do not attempt
voltage
23. REPLACEMENT
replacement
routine
PARTS:
substitutions
CHECK:
vase) should
26. WARNING:
accessible,
ATTENTION:
conditions:
Refer all servicing
When replacement
may result
Upon completion
safety checks to determine
25. The apparatus
27.
or other hazards.
this TV yourself
should
as opening
to qualified
parts are required,
parts with the same characteristics
Unauthorized
24. SAFETY
to service
as the original
in fire, electric
of any service
shock,
or removing
service
be sure that the service
parts specified
to any dripping
or splashing,
technician
uses
by the manufacturer.
or other hazards.
to this TV, ask the service
that the TV is in proper operating
not be exposed
you to
personnel.
injury to persons
or repairs
covers may expose
technician
to perform
condition.
and no objects
filled with liquids
(such as a
be placed on the apparatus.
Plug the power cord into a power
in case if the power
outlet
needs to be immediately
This device complies
received,
28. CAUTION:
maintained.
To reduce
including
access to a power cord connector
interference
the risk of electric
interference,
shock, the grounding
is subject
to the following
and (2) this device must accept any
that may cause undesired
3
is readily
disconnected.
with Part 15 of the FCC Rules. Operation
(1) this device may not cause harmful
interference
where
operation.
of the center
pin of this plug must be
two