Download English

English
General Operation
For rear washing - mild
● Press the MILD button [B].
[B]
* Water will drip from the nozzle. This washes the nozzle before use.
The nozzle extends and water sprays.
● Press the STOP button [A].
[A]
* The spray will stop and the nozzle will retract.
To adjust the water pressure
Press or on the “SPRAY
STRENGTH” button [C].
[C]
* The water pressure can be adjusted to any of six levels. Select the
water pressure as desired.
* The water pressure level is indicated on the LCD.
To change the washing mode
Press the MILD button [B] a second time during rear washing - mild.
* Pressing MILD during rear washing - mild alters the mode.
* Once the washing is stopped, the washing mode starts with rear washing - mild when MILD is pressed.
Rear washing - mild
Rear washing/rear washing - mild
Equipped with an auto-stop function
which terminates washing after 2
minutes.
However, when the massage function
or oscillating spray is activated while
the rear washing or rear washing - mild
function is performed, the washing time
will be lengthened by 2 minutes. This
will automatically stop after the washing
has been performed for up to 6 minutes
in total.
Oscillating spray
Oscillating spray - narrow
The nozzle moves back and forth
to wash a wide range.
The nozzle moves back and forth over
a short span for more thorough cleansing.
Self-cleaning nozzle
This function is provided to automatically
clean the nozzle before and after the
rear washing or rear washing - mild
function is performed.
20
Water comes out from a point
near the nozzles.
When sitting on the toilet seat or
pressing any button for the shower,
water comes out from a point near the
nozzles in preparation to spray warm
water. It may take a short time to warm
the water in winter or in cold regions.
Water comes out either immediately
after sitting down on the toilet seat,
or before and after washing. This is a
requirement to achieve the function, and
so the user should not regard this as a
problem. (→ Page 43)