Download Autotool 2000 CPK
Transcript
53 Position tie advancer 1. Operate bandoleer cutter POSSIBLE CAUSE SOLUTION No tie advancer present. ff Push the trigger for the bandoleer cutter to the left. The tie advancer is faulty. ff Open the gate. Position of tie advancer appears as the next message on the display. Position tie advancer No tie advancer present. ff If applicable, carefully remove the cable-tie residues. ff Open the roller block, à „Checking tie advancer“ on page 28. 1. Press Reset button 2. Check position tie advancer IT Position of tie advancer appears as the next message on the display. PT 54 ES FR 2. Open gate DE DISPLAY MESSAGE GB Troubleshooting Position tie advancer No tie advancer present. ff Check the tie advancer. ff Insert new tie advancer, à „Checking tie advancer“ on page 28. Close gate NL 55 ff Close the gate. 57 Error, drum The cable ties are pulled in at an angle. 1. Remove cable-tie residues ff If applicable, carefully remove the cable-tie residues. ff Press the Reset button. Error, gate appears as the next message on the display. 2. Press Reset button ff Close the gate. ff Load new cable ties, à „Loading cable ties“ on page 12. 58 Overload 1. Operate bandoleer cutter 2. Open gate The drum is blocked. ff Push the trigger for the bandoleer cutter to the left. or ff Open the gate. The cable tie is not cut off. ff Open the two transparent covers at the gate, à „Troubleshooting a cable-tie malfunction“ on page 25. or FI Error, drum appears as the next message on the display. PL ff Open the two transparent covers at the gate, à „Troubleshooting a cable-tie malfunction“ on page 25. 2. Open gate SE ff Open the gate. CZ 1. Operate bandoleer cutter ff Push the trigger for the bandoleer cutter to the left. HU The cable ties are pulled in at an angle. SI Error, drum RO 56 NO Error, gate appears as the next message on the display. DK ff Press the Reset button. ff Check the sensor lever and the end cap for wear. TR ff Cut off the cable-tie head. 1. Remove cable-tie residues 2. Press Reset button The drum is blocked. ff If applicable, carefully remove the cable-tie residues. or ff Press the Reset button. The cable tie is not cut off. Error, gate appears as the next message on the display. ff Close the gate. KO Overload ZH 59 JP Error, drum appears as the next message on the display. AT2000 CPK • Operating Instructions • 04-2015 • 106-29004 23