Download TomTom NAVIGATOR Quick Start Guide

NAVIGATOR_QSG.book Page 4 Monday, May 1, 2006 5:02 PM
EN
Before You Start...
Before
You
Start...
questions by tapping the screen or by
using the joystick.
Installation
If you have purchased TomTom
NAVIGATOR on a TomTom memory card,
insert the memory card in your device.
Then go to step 4 below.
Note: TomTom GPS receivers connect
automatically when you start TomTom
NAVIGATOR. If you are using a
different GPS receiver, refer to the
receiver’s user manual for
instructions.
If you are installing TomTom NAVIGATOR
from a DVD do the following:
1. Connect your device to your
computer, or insert the memory card
you are using into a card reader/writer
attached to your computer.
Tap or select buttons
On devices with a touchscreen you tap
buttons. On devices without a
touchscreen you select buttons. This user
guide always refers to tapping buttons.
2. Insert the DVD in your computer.
3. Follow the instructions in the setup
program.
On mobile phones, many buttons are
numbered. You can select those buttons
using the number keys on your phone.
When setup is finished, disconnect
your device from your computer or
insert the memory card into your
device.
Activation
You will be asked how you want to
activate the map that comes with
NAVIGATOR. There are two ways to do
this:
4. Switch on your GPS receiver.
5. Launch TomTom NAVIGATOR by
tapping or selecting the TomTom
button in your device menu.
•
You have to answer a few questions to set
up TomTom NAVIGATOR. Answer the
4
Automatically
To activate automatically, your device
must have an active wireless data
connection (GPRS, EDGE, UMTS or
CDMA).