Download to PDF User Guide / Manual

STEP 4
Be sure Polisher is off. Turn speed dial to a speed of 2. Hold pad against surface to be
polished, and switch Polisher on. Once the polish has spread well, the Polisher can
be used at a higher speed such as 3 or 4.
STEP 5
Hold pad flat against surface, and slowly move the
pad in the pattern shown to the right. Overlap each
pass halfway, while polishing up and down, then
left to right. DO NOT apply too much pressure. On
a horizontal surface, the weight of the machine is
enough. On a vertical surface, apply light pressure.
BEGIN HERE
STEP 6
Once you’ve polished enough that only a thin haze
layer of polish remains, you may stop. Check to
see you’ve covered all the areas necessary. The
remainder of the polish can then be removed with a
Microfiber Bonnet.
STEP 7
To remove any leftover residue, place the
Microfiber Bonnet directly on the Pro Polish Pad
and work the Bonnet into the same pattern as
Step 5, but on speed 2. You will notice the vapor
barrier on the inside of the Microfiber Bonnet. This
unique design is to prevent any Pro Polish or wax
from transferring onto the Bonnet.
www.shurhold.com
9