Download MultiFaceSoftware 3

Chapter 2
Netwerk ParNet
For owners of a MultiFaceCard the installation procedure
continues. The following window asks »Do you wish to install the
PitNet« - the networking software. Before immediately clicking
on »Yes«, please read the section in chapter 3 about »ParNet«,
»PitNet« and »PiaNet« first. If you haven't read these sections yet
you should rather click »No«. The Installation process will then be
terminated as described above.
The »PitNet« installation begins with the question of the number
(»Unit«) of this Amiga. It doesn't matter whether you choose
»Unit0« or »Unit1« as long as you choose the opposite for the
Amiga on the other side of the cable. Just click »Proceed« and the
installation program will do the rest. That is definitely all for now.
The program terminates as described above.
2.2 Manual Installation
It may be possible that the automatic installation procedure as
described above does not suit your expectation. This section gives
you information that you might need for a manual installation. In
any case please read the section »Automatic Installation« anyway.
That section covers basic information, that you will need for a
manual installation.
A manual installation can be as easy as moving an icon. After
having started the Workbench place the »MFC« icon from the
»Expansion«-directory of the »MFS3« disk in the same directory
(»Expansion«) of your Workbench. After the next boot process of
your Amiga the basic drivers will be activated automatically.
It is advisable to copy the program »DuartPrefs« from the »Prefs«
directory to your system so that it is easily available, if you should
need it in the future.
20