Download INSTALLATION MANUAL

girrI 130
TECHNICAL SPECIFICATIONS
ELECTRIC MOTOR
OVERALL DIMENSIONS
275
270
300
10°
Power output...........................................................0.25 KW (0.33 HP)
Supply voltage ..............................................................................230 V
Frequency......................................................................................50 Hz
Absorbed power .........................................................................530 W
Absorbed current..........................................................................2.5 A
Insulation class....................................................................................F
Motor rotation speed ........................................................1˙320 r.p.m.
Capacitor.............................................................................20 µF/450 V
Intermittent service .........................................................................S 3
103
ELECTRO-MECHANICAL OPERATOR
210
240
175
270
175
120
55
FIXING BASE PLATE
30
Type of lubrication by AGIP .....................................MU/EP1 grease
Travel speed ..........................................................................10 m/min.
Rated torque.............................................................................28.0 Nm
Weight of the operator................................................................14 Kg
Static weight of the gate ..........................................................400 Kg
Gear rating.......................................................................................1/30
Working temperature......................................................–25°C +70°C
Protection standards..................................................................IP 535
Duty cycles................30 sec. Open - 30 sec. Dwell - 30 sec. Close
Time of one complete cycle..........................................................90 s
Complete cycles Open-Dwell-Close...............................No 40/hour
Cycles per year, 8 hour service per day........................No 116˙000
WARNINGS
- Before installing the equipment carry out a Risk Analysis and fit any required device in compliance with EN 12445 and
EN 12453 Safety Norms.
- lt is highly recommended to keep to these instructions. Check the specifications on the motor label with the site voltage supply.
- Dispose properly of the packaging materials such as cardboard, nylon and polystyrene through specialized companies.
- Should the operator be removed for servicing or repairing, do not cut away the electrical wires, but properly remove the
terminal boards from their seat.
- All the equipment must be duly earthed by means of the specifically provided earthing screw.
- It is also advised to carefully read the regulations, advice and suggestions in the book “Safety Norms”.
The growth of MECCANICA FADINI has always been based on the development of guaranteed products thanks to our “TOTAL
QUALITY CONTROL” system which ensures constant quality standards, updated knowledge of the European Standards and
compliance with their requirements, in view of an ever increasing process of improvement.
®
Made in Italy
The “CE” mark certifies that the operator conforms to the essential requirements of the European Directive art. 10 EEC
73/23, in relation to the manufacturer’s declaration for the supplied items, in compliance with the body of the regulations
ISO 9000= UNI EN 29000. Automation in conformity to EN 12453, EN 12445 safety standards.
EUROPEAN MARK CERTIFYING CONFORMITY TO THE
ESSENTIAL REQUIREMENTS OF THE STANDARDS 98/37/EC
• DECLARATION OF CONFORMITY
• SAFETY NORMS
• EN 12453, EN 12445 STANDARDS
• CEI EN 60204-1 STANDARDS
• WARRANTY CERTIFICATE ON THE CUSTOMER’S REQUEST
®
s.n.c.
AUTOMATIC GATE MANUFACTURERS
Distributor’s box
The manufacturers reserve the right to change the products without any previous notice
Via Mantova, 177/A - 37053 Cerea (Verona) Italy - Tel. +39 0442 330422 r.a. - Fax +39 0442 331054 - e-mail: [email protected] - www.fadini.net
Lineagrafica.it
To achieve an optimum performance and longer life of the equipment and in observance of the safety regulations, it is recommended
that inspections and proper maintenance are made by qualified technicians to the whole installation ie. both the mechanical and
electronic parts, as well as wiring.
- Mechanical parts: maintenance every 6 months approx.
- Electronic apparatus and safety equipment: maintenance every month approx.
11-2005
CHECKING AND MAINTENANCE: