Download Model 2704 High performance Controller/programmer User Guide

Programmer Configuration
2704 Controller
4.11.1. PROGRAM GROUPS Group Edit Page
This page is available in operator and configuration level.
Table Number:
4.11.1.
Parameter
Name
Group Number
These parameters allow you to set up
individual Program Groups
Parameter Description
To select the Group number
Load Programs allows a
program to be entered and run
directly
Value
Default
‘Load
Programs’ or
select from 1
to 20
Load
Programs
L1
0:00:00
L3
Delayed Start
To set a time delay before the
program will run
h:mm:ss
Group Status
The program group can be
controlled from this parameter
Reset
The status of the program is
also shown by text and
symbols at the top of this
display
PSP1
To select the profile to be run in
the group.
Not Used means PSP1 is not
part of the group
PROGRAM GROUPS
(Group Edit Page)
Access
Level
L1
Run
Hold
Complete
Not Used
L1
01:PSP1:P1
to
20:PSP1;P20
01:PSP1:P1 means PSP1 is
selected from program 1 to 20
PSP2
As above
L1
PSP3
As above
Group Name
A user configurable name
L1
By default if Group Number =
Load Programs then Group
Name = USER SELECT.
USER
SELECT
GROUP
NAME
L1
Group 1 to 20
To customise the name press
 or  to change the digit with
the flashing cursor.
Press  to advance the cursor
Group Run
Group Run
Off
On
R/O
L3 R/O
Group Hold
Group Hold
Off
On
R/O
L3 R/O
Group Reset
Group Reset
Off
On
R/O
L3 R/O
Group End
Group End
Off
On
R/O
L3 R/O
4-28
User Guide
Part No HA026502
Issue 5.0
Dec-04