Download TROUBLESHOOTING GUIDE
Transcript
OmniPCX Enterprise Session Iniation Protcol (SIP) TROUBLESHOOTING GUIDE No.0069 - The Trunk Group supports high bandwidth calls and as a consequence low bandwidth calls too. Both G711 and system codec (G729/G723) can be used. Initial SDP offer content, general case (calling party is not a SIP device nor a SIP trunk). Trunk Group compression type Default Default G711 Intra/Extra IP domain algorithm With Compression Without Compression With Compression G711 Without Compression SDP System algorithm only (G729 for instance) System algorithm only (G729 for instance) System algorithm (G729 for instance) in first position and PCM (A or MU) in the second position PCM (A or MU) in first position and system algorithm (G729 for instance) in the second position 8.3.1 nitial answer : the answer to an initial offer on incoming call Pre-requisite : The SIP equipment must at least propose one codec supported by OXE in its offer. OXE Trunk Group used for incoming calls (managed in External SIP Gateway) must be managed with algo=G711. OXE always answers with one codec only : The one proposed in a by the SIP equipment in case of mono-codec offer. The best one in case of multicodec offer, taking into account : - SIP equipment list order (calling party prefered codec). - Called party extra-domain codec. The answer may be send in 18x and/or 200OK depending on « SDP in 18x » management. OXE initial SDP answer summary (incoming trunk group algo = G711). SIP equipment SDP Offer G729, G711 G729, G711 G711, G729 G711, G729 G711 G711 Intra/Extra IP domain algorithm With Compression Without Compression With Compression Without Compression With Compression Without Compression Codec use G729 G729 G729 G711 G711 G711 For SEPLOS users, the OXE is acting as an IPtouch. 8.4 PCS The SIP is totally operational on PCS; it is able to secure all types of SIP elements, but the SIP equipment connected must be tested to be sure that it will be able to connect and working on the PCS. In case of spatial redundancy, the nodename manage on the PCSs must be the same than the one managed on the CPUs. Ed. 07 33 TG0069