Download Digital Temperature Controller User's Manual

1.4 Setting Switches
•
● E5CSV
Insert the tool (refer to the diagram) into the two tool insertion holes
(one on the top and one on the bottom) and release the hooks. Then,
grip the front panel and pull out towards you to remove it.
Tool insertion hole
Alarm mode switch *1
Temperature range switch
Tool insertion hole
Flat-blade screwdriver
(Unit: mm)
20 min.
Overview
Section 1 Overview
Control mode switches
INIT switch *2
Protect swtich
*1. The alarm mode switch is not provided on models without alarms.
*2. The INIT switch is always OFF during normal operation.
● E5CS-U
•
Pull forward on the front door opening/closing groove located on the
right of the front panel and open the front door. Only open the front
door to set the switches. When not setting the switches, always use
the E5CS-U with the front door closed.
Front door
opening/closing
groove
Protect switch
INIT switch *2
Front door
Control mode switches
Alarm mode switch *1
Temperature range switch
*1. The alarm mode switch is not provided on models without alarms.
*2. The INIT switch is always OFF during normal operation.
1-8